SupplyDiva How we make Metal Blanks for Jewelry Making


A behind the scenes look at how we make our products. See how we made the blanks you use in your jewelry! Our metal blanks begin with a unique cutter, our workshop has hundreds we have produced over the years. The cutter must be installed in the machine and centered properly. We match up the type and gauge of metal from your order, then we can cut the blanks. Afterwards each blank has rough edges which we file and clean away, this is called deburring. Finally the blanks go through an acid bath and a tumbler before being packed up and shipped. 

 Check out our YouTube page and follow us to see more upcoming videos! We are currently shooting a video on how we cast our metal charms, and how we make our claw rings and bracelets.